The single-head pipe bending machine manufacturer has also analyzed the structural and technological characteristics of the pipe bender for everyone. In fact, the use of pipe benders is quite common around us. In fact, the single-head pipe bender manufacturer said that the use steps of the pipe bender are relatively simple. As long as you follow the prescribed steps, there will be no big problems, but there are still some details that you need to pay attention to. Next, let's talk about the use of the pipe bender and the precautions for use.
The single-head pipe bending machine manufacturer analyzes its use method as follows:
(1) Refer to the instruction manual of the electric oil pump.
(2) First screw the working oil cylinder into the internal thread of the square block so that the rear end of the oil cylinder is mounted on the wheel of the bracket downward.
(3) Select the die head according to the outer diameter of the pipe to be bent, set it on the plunger, place the corresponding grooves of the two rollers toward the die head, and then put it into the corresponding size flower plate hole, and then cover the upper flower plate , Insert the elbow pipe into the groove, then pull back the movable part of the quick connector at the end of the high-pressure oil pipe and put it on the joint of the working oil cylinder, tighten the oil drain screw on the electric oil pump to bend the pipe . After bending the pipe, loosen the oil drain screw and the plunger will automatically reset.
The single-head pipe bending machine manufacturer analyzes its use precautions as follows:
(1) Refer to the operation manual of the electric oil pump.
(2) Never remove the quick connector when there is a load.
(3) This machine uses oil as the medium. It is necessary to clean and maintain the oil and the machine to avoid clogging or oil leakage, which will affect the operation.